01621 868805(UK)
+44 (0)1621 868805

Send us an Email

KMR Photographic Services Ltd..©2005
         

Information

Commonly asked questions.
How do I clean my seals?
How should I clean my equipment?
How do I stop my unit from leaking?
What do I do if I do get a leak?
What do I check if my equipment just stops working?
Why are synch leads so temperamental?
How should I store my equipment when travelling or when not in use?
How often should I get my equipment serviced?
What 'O'-ring grease should I use?
How do I know if a second hand unit is good?
How should I get my equipment to you?

How should I clean my equipment?
Always thoroughly rinse your equipment in fresh water after each dive. If you allow it to dry out before rinsing its too late the damage is done. If you are unable to rinse in fresh water keep it wet until you can. After rinsing for 20mins while working all the functions, change the water and leave to soak. Look at the edges of any indents or protrusions and check for salt or dirt deposits this is a sure sign that you are not rinsing enough. I often take a small soft paintbrush to brush the equipment down while rinsing, this speeds up the cleaning process and accesses parts that are difficult to reach, but extreme care must be taken not to drag lubricant away or to leave behind bristles from your brush. Keep an eye out for signs of scratching or surface pitting this could be serious and may require expert inspection. Check the equipment for large or hard pieces of debris, if present try washing in warm water and rinse off in fresh.

If what you seek is not here or not clear - contact us directly and we shall endeavour to solve your problem



Privacy Policy
Conditions
Site Map
KMR Photographic Services Ltd..©2005 www.aquaphot.com The Underwater Camera Company for all Types of
Underwater photography equipment